Hello, I'm trying to set up my mutant 2400 to use sat and cable. what is the best cam to use? i've tried adding both lines to newcamd but it doesn't clear the cable all the time.
I wasn't sure if i need to use 2 different cams so the dont conflict.
I'm only using not sharing so don't need to set up a server.
Any help would be appreciated/
Spud
which cam for both V*rgin and Sk*
- spudly
- Thread is marked as Resolved.
There are 11 replies in this Thread which was already clicked 1,116 times. The last Post () by BallBuster.
-
-
cable, I would like to know how to do that.
thanks -
oscam simple
-
99% of cable shares available are from payservers and I doubt they would agree to you using oscam so best to use mgcamd
-
Thanks for the replies.
can i put both lines in the same config newcam.list? as this is where i seem to run into problems. sat clears but not cable. -
Thanks for the replies.
can i put both lines in the same config newcam.list? as this is where i seem to run into problems. sat clears but not cable.Leave the sat one in Mgcamd and put the cable one in CCcam.cfg and use cccam
-
I was told they would block cable if it was on cccam
-
-
I was told they would block cable if it was on cccam
Cccam behaves erratically as client emu for some cable/nagra caids, the preferred emu is mgcamd or rqcamd, I much prefer the latter one ;)
-
oscam
-
Use mgcamd for both
& in newcamd.listCWS = satellite
CWS = cable -
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!