Need help Adding N line to Technomate Nano SE

robbostech · May 9th 2015

Hi again guys. My provider has supplied me with the N line details in a Ccam.cfg file (Notepad). I keep reading how to insert a C line into a Technomate Nano SE but I'm left wondering how or where do I insert my N line? Many thanks if someone can point me in the right direction.

**mckee25** · May 10th 2015

Who is your provider???? is this someone who you paid for this line????

robbostech · May 10th 2015

Ignore my rantings above. A little alcohol fuddled last night. DUH!!!! :71:

1st · May 10th 2015

Quote from robbostech

Hi again guys. My provider has supplied me with the N line details in a Ccam.cfg file (Notepad). I keep reading how to insert a C line into a Technomate Nano SE but I'm left wondering how or where do I insert my N line? Many thanks if someone can point me in the right direction.

you need to ftp it to the box in etc/ then just copy and past and mack sure you have ccam enabled on your box

robbostech · May 10th 2015

Cheers 1st. That makes perfect sense now. Thanks a lot mate. Much appreciated.

**master G** · May 10th 2015

It`s the same process as adding a C line..

File

DCC - Dreambox Control Center by BernyR

The program is intended exclusively for handling Enigma2 boxes over the network. Enigma1 version is also attached.

master G

May 12th 2019

robbostech · May 10th 2015

Fantastic master G. Top man.

Need help Adding N line to Technomate Nano SE

Your resource for CCcam softcam

Participate now!

Share

Tags