Hi, firstly let me appologise for this post as i know it's on here somewhere but can't find it so could someone please point me to the post that shows me how to flash an openbox via the rs232 port.
Thanks
There are 2 replies in this Thread which was already clicked 937 times. The last Post () by lutz diagram.
Hi, firstly let me appologise for this post as i know it's on here somewhere but can't find it so could someone please point me to the post that shows me how to flash an openbox via the rs232 port.
Thanks
How to Recover a Dead Openbox/Skybox
one way to recover the box after being dead to reflash it with a serial cable RS232 (null modem cable)
Things needed for recovery
1) A laptop or a Desktop computer with Serial Port
2) A null modem cable with female connectors at both ends.
3) A dead open/ skybox
4) Firmware or Clone safe firmware
5) An Upgrade tool (software)
Method:
Connect your Laptop/ Desktop with your Box via RS232 Cable.
Make sure the Box is turned off.
Open the upgrade tool by double clicking on the file (Erom Upgrade).
Select the Correct COM Port from the drop down menu.
If you are not sure which Port is the correct one thne go to the Device Manager and find out which COM Port is Serial Port on your laptop/Desktop ( in my case it was COM4).
Leave the bit rate on 115200.
Parity: Even
Operate Mode: Upgrade
Browse the Clone safe firmware.
IMPORTANT: Check (Include Bootloader) otherwise the recovery will not work.
Press 'NEXT'
It will give you a message, "Snychronising STB" "Please reset target"
Now Turn the Box ON
The program will give you another message saying " Connection made" or Synchronised"
It will start downloading the software to the box by showing its progress.
When the download is completed It will show a message about burning the flash
Click Next or Ok to complete the process.
DO NOT turn off the Box in the process.
After Flashing is completed the Box will restart. You will see the front panel switched on and you will also a picture on TV
Tip: It's difficult to find a laptop/desktop with a serial port. There is a USB to serial port converters available in the market. Best to buy one on fleabay. The cheapest is under £2. I recommend HL-340. It supports Win XP, Vista and Win7 32 bit. You can download the driver for it from the internet.
I personally recommend to try to use a laptop/ desktop with the serial port instead of using a converter. And make sure the the PC speed is similar to the program speed.
But as Serial port cant carry a big bulk of data so make sure that the highest speed is selected in the recovery program which is "115200".
I no longer have a openbox/skybox moved on so you will have to find upgrade tool software and firmware yourself.
each model had it's own version of loader.
The instructions should say hit next on the loader and you will see a progress bar that eventually goes to 100%,this just loads the firmware to ram.You have to hit next again to actually burn the firmware to flash.
You will see another bar go to 100% then the loader will say next finished exit.exit
Don’t have an account yet? Register yourself now and be a part of our community!