Smargo Help

There are 10 replies in this Thread which was already clicked 2,960 times. The last Post () by master G.

    Hi, Could anyone help me get my smargo reader working. I am new to linux so please make it idiot proof. I have ubntu pc server running with oscam CCcam and I cannot seem to get smargo reader working. when #lsusb I see my smargo device id but when I try #pcsc_scan it just hangs saying waiting for the first reader....
    Also #opensc-tool --list-readers says, No smart card readers found. Is there something obvious I am doing wrong
    Thanks in advance

    pcsc ,,, try smartreader for protocol, well and device = what ever it says on lsusb i.e 002 :003.. but it might help if others could see your configs, im a noob at this, still learning

    Hi config file is


    [reader]
    label = slyuk
    protocol = SmartReader
    enable = 1
    device = /dev/ttyUSB0
    #if you use smartreader and device with a bus id, hash out detect as its not needed.
    detect = cd
    boxid =
    mhz = 600
    card mhz = 600
    ident = 0963:000000
    blockemm-u = 0
    blockemm-s = 0
    blockemm-g = 1
    blockemm-unknown = 1
    emmcache = 1,3,2
    group = 1
    lb_weight = 101
    caid = 0963


    but i think its either a problem with smargo or ubuntu
    thanks for help

    [reader]
    label = slyuk1
    protocol = smartreader
    # edit the next line with the correct detais from using LSUSB in ubuntu to get the smargo
    device = 002:004
    caid = 0963
    ecmwhitelist = 0963:3E,4E,42,44,45,47,6A,6B,6F,62,68,69,7C,7D,7E,72,73,77,79,80,8B
    detect = cd
    mhz = 686
    cardmhz = 357
    group = 1
    emmcache = 1,1,2
    blockemm-unknown = 1
    blockemm-g = 1

    [reader]
    label = ***
    protocol = smartreader
    device = 003:002
    caid = 0963
    boxid = 00000000
    ecmwhitelist = 0963: 3E,4E,42,44,45,47,6A,6B,6F,62,68,69,7C,7D,7E,72,73,77,79,80,8B
    detect = cd
    mhz = 369
    cardmhz = 368
    ident = 0963:000000
    group = 1
    emmcache = 1,3,2
    blockemm-unknown = 1
    blockemm-g = 1
    lb_weight = 101
    m8, i no this one is working, you using oscam only or oscam/cccam

    Hi, Problem is when i pcsc-scan in linux it says no reader found and ive tried with device id. So for some reason my smargo's not being seen at all if you get me

    In terminal write is lsusb and it should tell u wat usb bus the smartgo is in. Example 001:004

    Hi found device id with lsusb its 002:002 but if i run opensc-tool --list-readers, its says no reader found. Also pcsc_scan just hangs looking for first reader.

Your resource for Linux TV servers and smart card readers.

Find software downloads, drivers, and support for server setup and card-sharing configurations. Set up a Linux-based TV server. Access downloads and support for server software and USB card readers for advanced TV reception and management