How make Beckup using DreamUP connected with RS-232 cable

**siny** · Nov 8th 2011

Warning DM must be disconnected from the power supply

Choose the serial port COM X in this case COM1 and I click on Connect, picture 1.

Now we will get the picture 2.

Now we can turn the power on dreambox.
It started reading DM picture 3.

When finished downloading click on Beckup and we get picture 4.

Now type the name of the file shown in "red" and I click on Save marked in "blue", picture 5.

Now begin daownloding Images from Dreambox will take a while, picture 6

When is over click "OK", picture 7.

When we do this will get picture 8. where you press Disconnect marked in red, and then Exit to get out DreamUP marked green

now make a backup was done...

edit: I do not know why my picture does not show in my post,but must click on the picture.thnx

Your dedicated resource for Enigma1 Dreambox support.