Xtrend ET8000 OSCAM CONFIGURATION

There is 1 reply in this Thread which was already clicked 1,691 times. The last Post () by codar.

    Good morning all, I've been trying to configure oscam on my recent acquisition ET8000 but always received 'oscam not config' message. I tried to configure it as advised in some tutorials on this forum but unfortunately, the end result isn't positive.
    Here is attached the oscam folder in case anybody can modify it or advise me on what to modify and how to install it in my receiver.
    Many thanks in advance for your HELP.:06:

    If it is your own card for 28.2, have a look here for configs:
    Also your oscam version is a bit dated.
    You could upgrade to a newer version using the vix feeds (I presume your running vix from your profile)
    Or alternatively, you could install our addons panel and install oscam from there:


    If it is only a share/line you have, you could use this handy tool to convert it into a reader (which goes into oscam.server file)

    iBffBYU.png

    Edited once, last by codar: More info ().

Your resource for OSCam softcam

Find configs, downloads, tutorials, and support for setting up and optimizing this open-source card server with wide protocol compatibility. Master the versatile OSCam softcam. Access support, configs, tutorials, and downloads for open-source card sharing and multi-protocol server management.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login