how to flasing pcd 9 on dm 600pvr ?

There is 1 reply in this Thread which was already clicked 894 times. The last Post () by master G.

    • Official Post

    Slightly different to other dreamboxes. You can either use the Dreamup software (takes ages) or use the method below instead.


    1. Boot the box, go to the communication menu and note the ip address.


    2. Run Dreambox Control Center, connect to the dreambox. Once the network is connected ok, click on the 'Telnet' option.


    3. In the telnet window, type the following, pressing <enter> at the end of each line.


    Code
    mount /boot -o remount,rw


    Code
    rm /boot/*


    Code
    reboot


    4. You should now get a message saying that the Dreambox is rebooting.


    5. Wait a few seconds and then run Internet Explorer, Firefox or whatever browser you use and enter the ip address of the Dreambox in the address bar.


    6. On the screen that appears, choose the 'Upgrade firmware' option, find the .nfi file and click the 'Flash' button.


    7. Once the progress bar reaches 100%, reboot the box

Your dedicated resource for Enigma1 Dreambox support.

Access downloads and troubleshooting for the DM500, DM600, and DM7020 legacy models. Support and downloads for classic Dreamboxes. Keep your DM500, DM600, or DM7020 running with Enigma1 software and community help.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login