Beginner HELP

There is 1 reply in this Thread which was already clicked 639 times. The last Post () by beachway.

    Hey guys ,


    I'm relatively new to CCCAM Even though i'm a bit familar with IPTV . Im at a point where i dont understand much and i really need a bit of help ...


    1. How Can i Use CCCAM Without an actual box , Not For Viewing Purposes , But For Resharing , how could i use specific channels , or simultaneous channels and output them to a specific rtmp server or such through decoding (.and enc) ..


    EDIT : By Without an actual box i mean by using it on My Linux Server .


    If That is possible and you can help me i'd really appreciate it alot .


    Cheers!

    You're going to need a cardreader. My advice is to start reading up on CSP then move onto Multics. Good luck on your quest.
    Once you get the basic concepts, you might actually work out that you don't actually need a card, however it does have its advantages.


    Sent from my GT-P3110 using Tapatalk

Your resource for CCcam softcam

Find downloads, configuration files, setup tutorials, and community support for card sharing and server management. Master CCcam configuration and card sharing. Access dedicated support, step-by-step tutorials, config files, and downloads for your Enigma2 setup.