In order to install Neutrino HD over official Firmware please follow the steps below.
- Download Neutrino HD software package which contains patch.bin and neutrino.bin fi le inside.
- Copy patch.bin fi le to your USB Memory stick (FAT32 formatted)
- Put the USB Stick into AZBox device and start the updating procedure trough Settings menu or by
- turning off and then turning on your AZBox.
- When initial software is installed, your AZBox will displayed IP address. (Note: for Ultra model, you
- have to note the IP address from the Settings menu or from your router, as it doesn’t have display).
- Run Neutrino Loader 1.1 (which You downloaded from Set Top Boxes, Media Center: High Definition | AZBOX) and enter the IP address
- (which was shown before) int the IP address fi eld of Neutrino Loader 1.1. Press button Upload.
- Once Upload button is pressed, Neutrino Loader will ask you to specify which fi le you want to be
- loaded.Please, select neutrino.bin fi le from Neutrino HD package (which You downloaded from www.
- azbox.com)
- After this fl ashing procedure starts, please wait until Neutrino Loader confi rm you that performing
- operations are fi nished.
- When you get the confi rmation message from Neutrino Loader, please remove the USB memory
stick from your AZBox
.
