hi guys I done total factory reset on my box but problem I'm having now is there nothing there to put my line in,help please
zgemma 2s box mgcamd
- big_baws15
- Closed
- Thread is marked as Resolved.
There are 7 replies in this Thread which was already clicked 950 times. The last Post () by jenseneverest.
-
-
hi guys I done total factory reset on my box but problem I'm having now is there nothing there to put my line in,help please
What image you running mate?
-
openvix bud
-
openvix bud
attached is the ipk file.
ftp to temp folder
install with software manager and reboot boxOr install tspanel and do it using that.
-
thanks bud,has this file all configed?
-
-
cheers bud had look that thread but how do I get it in and where do I put it,sorry bud still newbie to it all
-
No problem, Remember all enigma2 boxes are the same. (except a few like amiko alien...)
Quick tut
There are 3 important files needed for sharing:
mg_cfg
cccamd.list
and
newcamd.listThe location of the files will depend on the image you use. In linux they will be in /var/keys or /usr/keys or look under the etc folder....
To allow mgcamd to share from both CCcam and Newcs, you must ensure that in the file mg_cfg, you edit the settings for the value of G: { x }
Settings are cumulative, you sum the values of the emus you want to connect to.. Have a quick look, but don’t dwell on it.
Set G: { 33 }
Simple so far? it gets easier..
Edit cccamd.list and paste in a C-line as normal e.g.
C: myfriend.dyndns.com 12000 myname mypass
close and save.
Edit newcamd.list
You may see something like:
CWS_KEEPALIVE = 300
CWS_INCOMING_PORT = 21000leave that alone..
If someone gives you an N-line share then this
N: myfriend.dyndns.com 15000 myname mypass 01 02 03 04 05 06 07 08 09 10 11 12 13 14
add it to the end of the newcamd.list like this:
CWS = myfriend.dyndns.com 15000 myname mypass 01 02 03 04 05 06 07 08 09 10 11 12 13 14 server1
Close and save
Restart mgcamd.
if you are missing files see here:
http://linuxsat-support.com/showthread.php?t=83085
and here:
MGCamd Support Forum
Configs, discussion, downloads and guides for MGCamd Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!