Hi,
Newbie to this so please bear with me.
Bought a zgemma star s2 and had problems from the off. The box crashed every time i tried to convert Ext3 to Ext4, then the channels started dropping out and the box turning itself off. this happened for about a week and eventually the box would not restart, was just on a constant loop with the display numbers counting up.
i'd had enough so flashed with OpenVix (was previously on OpenATV)
Found the set up great and all installed well.
Then realised i had no BslyB channels showing, although they are are listed in the EPG with all listings info present.
Had a read up and realised there was no Ccam on the box so followed a step by step guide and using FileZilla uploaded 2.2.1 ccam to /tmp folder and a config file to /etc folder.
My Ccam is now showing, with a green tick next to it, on 'Softcam Manager'
If i go into Ccam info/General however, i have the below showing:
Available shares: 0
Version: 2.2.1
Current time: 15.40
Node ID: 68b43f780b6c9e6a
Uptime: 00d 03.29.23
Connected clients: 0
Active clients: 0
Total handled client ecm's: 0
total handled client emm's: 0
Peak load (max queued requests per worker thread):
Is this the reason i can't view sly channels? Or is there something else i need to do? I'm at my witts end.
The bloke i bought it off isn't coming back to my emails and i'm almost at the point of wasting another £155 on a new box.
Any help would be extremely appreciated
