Hi! Great job !! I have just one question for you. When I turn off my device with my remote it works but its on standby.. I don't want that for several reasons. but when I turn it of by using the menu in the box for turnoff/restart it shots down completely. Then you have to turn the power button on/off and I can't use my remote.. It was not like this before. It happened after your update.Should it be like that? thanks for your help and work
power button on/off
- adam1890
- Thread is marked as Resolved.
-
What image are you using and who's update?????
-
OpenATV 5.1 Vu+Solo2 update for box
- - - Updated - - -
if I flash the box and there is an update should i update or just ignore it
I would always update bud as this usually contains updated drivers and fixes for bugs in the image etc.....
-
Change the mode on your remote, it may become usable again (or may not but worth a go, quicker than trying a fresh install)
-
You can customise what the buttons do in the advanced customise section of the setting. Perhaps the default settings are different on the update.
-
master G
Moved the thread from forum Vu+ SOLO2 Support to forum VU+ SOLO 2.
VU+ SOLO 2 PVR Ready Linux Enigma2 Receiver Full HD 1080p
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!
