you write click the file to see the options menu...
Is there a certain folder in usr/bin that I need to send the file to? Are keys already uploaded in this file or do I need to do that. When I hit the blue button it tells me that I have 2 cams installed- common interface and Oscam-EMU svn 10896. However it isn't opening any pv channels for me.
I managed to get the ipk file installed but when I get into usr/bin I don't see any options to change the permission or to rename the oscam.
@ contactc
you can look here for DM 800HD >> BlackHole-2.1.6-OE2.0-dm800-ssl84d
Install the ipk file >> enigma2-plugin-cams-oscam-emu-svn10896_blackhole_all.ipk attached and replace bin file with that in davvos post
How do I install the ipk file? As an image or with filezilla? If with filezilla, what folder will I find enigma2-plugin-cams-oscam-emu? Where do I find the bin file? Sorry for all the questions but I'm quite a novice at this.
Your help is greatly appreciated.:thumb:
Is BH 2,1.7 ok, that is the image I have on my dm atm.
Thanks for your reply. I intend on using my dreambox 800 hd although I also hsve a Vu+Solo 2.
I'm a bit new to E2, will this work with a BH image? Where do I send the oscam file?
I'd like to change the image in my dm800 but I can't communicate with the receiver. I type in the ip addy on my laptop and all I get is a 404 Not Found error. I have been doing this for years and have never encountered this problem. I recently changed my internet service and this also happens with my vu+solo2 as well.
I'm just wondering if patch 1.39 is what we should use for the d15 as 1.40 does not allow access to the cas menu.
Still cannot access powervu even with patch 1.40 on the dr hd d15. I t has been stated that the receivers are all the same but its menu is much different from the tm 5402 m3. All I can access is biss and even at that I can't change anything.
Thanks for the information, much appreciated.
Would be great if I could access that secret menu.
I was under the impression that the new 1.40 fw for the d15 was to support powervu key insertion but I can't figure out how to even access that area to do so for any form of encryption.
Thanks for the reply. There are parts of the fw upgrades that do address the dx part to this receiver as I've noticed with blind scan issues. You are right that encryptions and or keys would be useless for me in NA, I just don't want it to affect the dx side of the box.
Anxiously awaiting the arrival of my dr hd d15 receiver and I noticed that fw upgrades on their official site are dated back to last year. I have only the intention of using this stb for true fta and no card share or iks; the fw upgrades found here are for a true dxer I'm assuming? Any help on this matter would be greatly appreciated.
I've tested at least 5 openbox/***box receivers and never had heat issues. If chilling the receiver works then keep it cooled.
Why don't you keep your stb off for a while like you mentioned for twenty minutes and then load a recovery file via rs232? Nothing to loose bud.
