Posts by tataos

thanks, I'll try it

I have Pure2 7.6 image installed on Zero 4K, installed openmultiboot and tried to load OpenATV 8.0 ALPHA, but near the end it throws an error, then I put OpenATV into the flash and tried to load Pure2 into openmultiboot and it throws me the same error at the end of the installation, does anyone have a similar problem?

After three reboots, a skin appeared.

vu zero 4k , pure2 7.6 image , after the last image update from 19.01. my skin doesn't work or crashes enigma. After that I reinserted a clean image and installed the skin again, when loading the skin, enigma crashes again. I changed a few skins and all the others work properly and load. Can someone check who is using the Pure 2 image.

I need a recommendation for oscam emu ipk and ipk configuration for vu zero mips processor. I have OpenAtv 7.4 installed

I did everything as written, still nothing, I give up, I have no more options. Thanks everyone for your help

I tried to insert the original image, it didn't help, I replaced the power supply, I have another faulty zero, but the power supply is fine, I have no more options, it turns on and only the Opeantv logo appears on the screen and nothing happens, I can't even connect to ftp to see anything, it doesn't even connect to the network.

I just turned on the receiver and it's stuck on the Openatv logo, it's not starting up or receiving any images, I know the installation procedure well but it's not responding to the installation at all. Is there any original image or recovery image I can try?

I know how to load an image, I've had it for ten or more years, but it's never happened to me that it wouldn't load an image from USB, not even an official image.