tested on vu+ duo also running mgcam 1.38 gone back to 2.21 cam as I got a lot of glitching with some freezes
Posts by gordyboy
-
-
thanks mate but would much prefer the actual file if you can upload
-
hi could someone add the 2.3 file to the cams for vix section
Thanks
-
anyone got an ipk file?
Thanks
-
cntrolbox then send the ipk file via ipk installer
-
Thanks for moving the post. I have a vu+ duo on vix 2.1. Should an existing cccam file and oscam or mgcamd work with blackhole ?
-
i was thinking of switching to blackhole and noticed the new 1.67 file. would i need any other file apart from that one thinking about a flash file? do you
have a working blackhole mgcamd file you could share?thanks
-
do you recommend upgrading to 2.3 vix as I have read conflicting stories
thanks
-
I am thinking about upgrading to 2.3. Could you provide me with working files?
Thanks
-
Re Your card is still being read by CCcam, remove the following lines from your cfg.
This also helped me when I removed the lines. Running much better
THANKS
-
i have the set up as you say What do yo think about the right configuration set up?
-
thanks sly and hotbird/19 east goes through a 3 way disq switch
-
yes twin tuner my set up is
tuner a BCM7335 DVB S2 NIM (internal) DVB S2 DiSeq A/B/C/D/ Sats Astra 1H/ASTA 1 KR/ASTRA 1L/ASTRA 1MTuner B BCM7335 DVB S2 NIM (internal) DVB S2 equal to tuner A
-
I have a sly dish and a dish with two lnb's for 13 and 19. I can record on sly but cant watch 13 or 19 at the same time but I can record either 13 or
19 and can watch sly.Any thoughts?
thanks
-
thats better once i deleted 1.38 and re-installed it appeared so now i am running cccam 2.0 and oscam
so far looks good thanks
-
tried again I can see it when I download plugins on the box but when I try and download it a quick message appears that I cant read and its not visible in softcams
-
got an error when installing it says it clashes file is already provided by package. Will i delete the existing 1.38?
-
just a qick one AI have edited files but not an ipk file How do you edit this for my ip address? Thanks
-
thanks i will test this later as I have to go out
by the way just wondering what image you are using mine is Vix
-
so on a vu+ duo box i have the option of selecting ccam 2.0.11 or ccam 2.2.1 or mgcamd 1.38
should the 2.2.011 cam be switched on but enable mgcamd1.38 at start up?thanks