i wont argue with you
but if you think chris has been given the wrong wall mount then blame him
i wont argue with you
but if you think chris has been given the wrong wall mount then blame him
Exactly but it has taken ages to get where we are at and if the guy cocked up in the first place as the OP does not know what's what we may as well help him so when installer calls back they can show that they know a little bit.
we are amateur installers
and i have installed many and many times i installed it wrong too
and if i installed one and that one complained but also adjusted it
i wouldn't go back
and that has happened
your learn more from doing it wrong
let the installer learn by his wrong
it's down to you
if you can't reach the dish
then all we write here is b######t
get the installer back
start again from 0.8 west
and you'll see the difference
this one
or is there another
i'm not going to scan the arc of my dish to find a channel i don't know or package or what sat
jenneneverest see if you can see these too with 80m
with some east sats
im in west london
have 80m dish motor sg-2100a setup with dm800se 2nd room
and i can see these
please try
pictures for to you see and try
i would also say search 5 west
dm800se cant see what it cant find but yours will
Satlink-st5150
is a nice tool to have
but for an amateur who may put up a dish once
it's expensive
thank god for my phone app
it will not start vu+ duo3
not surprised doesn't exist
have you looked inside the /etc/tuxbox/config
to see what the problem is
How to Multistream ZeonBud T2-MI 4.8°E & Abertis package on Hispasat 30 West
i would ask and read there
my guess same as mentioned
thanks for that
i have read that i guess around march when it was put there
i bought the 7s mainly for IPTV which is it main good point
during full lockdown (this one is not)
i bought a c120 lnb from sweden
put it on and worked like a charm
with the settings you mention on that post
but if i replace with any other LNB ie them 3 new one's i have
it goes back to a dead-duck
but thanks for putting that info here
i accepted my box for what it is great iptv but as a sat box at least in my case hope not others
it's a 3 out 10 if you dont mind sticking to 1 sat
Display MoreDisplay Moreastra 23.5 east
DVB-S2
11739
Vertical
29990
2/3 (sometimes AUTO is best )
8PSK
I don't think you can adjust it through the receiver?
https://www.octagon-germany.eu…1028P_HD-NOBLENCE_ENG.pdf
are you sure
i've never used that box but reading that says you can
i added this as i did'nt see your last post
well done on getting stronger signal
just do a scan
astra 23.5 east
DVB-S2
11739
Vertical
29990
2/3 (sometimes AUTO is best )
8PSK
i've a channel master dish with it's own feedhorn
that gibertini wont go on mine
more like this one
i own 3 new one's of these
plus one other i got from sweden
these are getting harder to find
dreambox two is DM dreamtwo
i can see the difference
hope you as owner of a DreamTwo can see it
some one before made a mistake
exactly the same PSU
it's not a power issue
it's a tuner issue with a certain high end c120 LNB its no problem
never used that box
but i googled
Zgemma H7S tuner problem
and found this on this site
other sites i missed out cos we cant link to others
use a ready made channel list
for a box that you know but haven't mentioned