Posts by Lendar

There should be, but I guess it wasnt published. My other option is to buy a healthy receiver and dump the loader from it.

Hello everyone,

I have a Vu+ Duo 4K SE receiver that is currently bricked.

I read some old tutorials so I am trying to recover it using Broadcom Broadband Studio 3.0 with a Cypress FX2LP USB board.

To proceed, I urgently need the correct:

• XML file for the BCM7445(S) chipset (for BBS to detect the NAND flash),

• and the bootloader file (CFE.bin) for the Duo 4K SE.

If anyone has these files (XML + CFE) or the full DeviceFiles package, I would be very grateful if you could share them.

Also, if you have experience or a guide for recovering the Duo 4K SE with BBS, that would be extremely helpful.

pasted-from-clipboard.png

Thanks in advance 🙏

Quote from bellejt

what are you realy looking for ? The 5 volt ? If so look where the connections to internal HDD are

I will, yes I want to isolate the VCC

Hello,

Does anyone know where the VCC on this model is? I assume the UART port the one near SATA box

I found ground which is at the end, the next 2 pins read 3.24 V on multimeter and the last one reads 0

Ok, got a fan and it cools the processor well, but still after 10-15 minutes cs starts breaking. Any idea what else could be causing this problem ?

Thx for the replies.
able2 I don't know how to get a cpu temp/free mem

mclarnonray I am pretty sure this is the problem because when i cool it down it works again. How did you solve your problem. I plan to put this on top of my box: http://thumbs4.ebaystatic.com/…vkKSFcbGdSj4USVLlnQDw.jpg

Update:
When I open my receiver, the cooler on processor is hot. Problems with overheating?

Hello,
I am using Hyperion 4.5 on my Amiko Alien 2
Problem is that CS starts breaking after 10-20 minutes, then I restart the receiver on the power button and it works again for another 10-20 minutes. I have tried on 2 different internet connections and on cccam, mgcamd and oscam. Always same results.