Rizwan Awan ..I think flash need to be repaired ,bad sector might be exists in flash ..AliRaza is master in this field ..you may send your box to Arifwala
Its my pleasure, if he agree
Posts by Rizwan77
-
-
Now trying to find some old PC, doubt with USB to DB9
-
All the steps for Putty done as Ali guided, but nothing apear in logging window, Blank
-
Place a online order, so wait, till gadget arrived
-
There is a other issue here, no laptop or PC have these DB9 ports, how to encounter ?
-
There is no supplied cable, only old RS232 , which I used few time with my old DM800, I think called Null modem
I don't see this cable in my store may be misplaced some where if I find I will share its picture .
Through google search I have found I had shared its connection diagram in my friend Johnny's post . I share pic here if u can make it ur self . Its not that kind difficult.
Yes, I try manage this , may have few DB9 connectors in some of my cupboard
-
There is no supplied cable, only old RS232 , which I used few time with my old DM800, I think called Null modem
-
More infos can be found here
https://jb8a8f8.com/support/in…232-chip-information.264/
CodeRJ12 auf Rückseite VU+ Ultimo 4K (6 Pins) DB9F Sub DB9 Female 9 Pin (2-reihig) Standard Comport früher auf PC heute braucht man usb2Seriell umwandler GND: RJ12 Pin 5 -> DB9F Pin 5 TX: RJ12 Pin 2 -> DB9F Pin 3 RX: RJ12 Pin 1 -> DB9F Pin 2Yes this is the exact method . he should fallow this procedure .
From previous posts, I think , its just DB9 connectors on both end, So, RJ12 on one end and DB9 on Box side.
-
Anyone have the connection diagram of serial cable for VU+solo2 ?
-
I have solo2 , tried to connect with putty on ip address , not with rs232, unable to figure out . When i try to connect , no success, its time out, without connection no chance for a log
-
how to reflash, when nothing responding ?
-
I put last known of my Box ip with port 22 , there is no connection on putty
-
Connect your box with putty console and see the output and share logs here .
Thanks Ali, if you are in Pak , can I send u my Box ?
-
Try to connecting with dcc but no success, lights of Ethernet port blinking, but its in deep standby
DCC is buggy... always better to use Putty in Telnet and then SSH mode,
TS
Ok, try it later today, can you mention which version of Putty and how to do that ?
-
Try to connecting with dcc but no success, lights of Ethernet port blinking, but its in deep standby
-
I want to try these Images on my old DM800HD , but its many years , after power on, its Open pli3 in it, someone guide how install any new image and which steps to follow, I simply forget all old methods for this box
-
few days back, as I power ON my solo2, its shows starting on front panel, then its blank, just showing font panel light as standby mode, when its touched, slight brighten , but nothing works, any suggestions in this regard ?
-
I have this working Image, Openvision 7.3 r66, Some issue with forum, unable to upload
-
Any one have last working Enigma2 Images for Wetek Play2 , kindly upload here
-
But, its old one, looking for latest oscam
