Hello everyone. I recently purchased a Zgemma H8.2H and suddenly the bulb didn't turn on at all and I couldn't communicate with it at all.
I found the tutorial here and repeated the steps indicated by NOKIAS, but at the end of the process I find this message.
The device communicates with the PC and the front bulb turns on, but when I unplug it from the outlet it simply doesn't do anything. Any suggestions where I'm wrong would be welcome.
Sorry, I translated with Google...
Thanks.
Platform Version: 5.3.12
HiBurn Version: 5.2.19
HiSilicon Technologies Co., Ltd. All rights reserved. (C) 2011-2019
Mod: Hi3716MV430
Platform Version: 5.3.12
HiBurn Version: 5.2.19
HiSilicon Technologies Co., Ltd. All rights reserved. (C) 2011-2019
Mod: Hi3716MV430
SerialPort has been connented, Please power off, then power on the device.
If it doesn't work, please try to repower on.
Bootrom start
Boot Media: NAND
####################################################################### ---- 9%
####################################################################### ---- 19%
####################################################################### ---- 29%
####################################################################### ---- 39%
####################################################################### ---- 49%
####################################################################### ---- 59%
####################################################################### ---- 69%
####################################################################### ---- 79%
####################################################################### ---- 89%
####################################################################### ---- 99%
# ---- 100%
Decrypt auxiliary code ...OK
Enter boot auxiliary code
Auxiliary code - v1.00
DDR code - V1.2.1 20160503
Build: Sep 27 2018 - 23:35:13
Reg Version: v1.1.0X
Reg Time: 2018/10/24 21:31:57
Reg Name: hi3716mv43dma_hi3716mv430_DDR3_512MB_16bitx1_2layers.reg
SVB...done!
DDR HW training...done!
DDR SW training......done!
Set cpu freq
Reg init success
Boot auxiliary code success
Bootrom success
System startup
Relocate Boot
Jump to C code
Fastboot 3.3.0-dirty (h8@zgemma_dev) (Sep 14 2021 - 13:41:35)
Fastboot: Version 3.3.0
Build Date: Sep 14 2021, 13:42:02
CPU: Hi3716Mv430
Boot Media: NAND
DDR Size: 512MB
Found flash memory controller hifmc100.
no found nand device.
Using default environment
*******************************
serial: 537000179A2B31C7
mac: 00:17:9A:2B:31:C7
*******************************
Net: upWarning: failed to set MAC address
, downWarning: failed to set MAC address
Boot Env on NAND
Env Offset: 0x00100000
Env Size: 0x00010000
Env Range: 0x00010000
*** Warning - Env offset is NOT aligned to NAND Flash block size, environment value is read only.
start download process.
Boot started successfully!
Send command: getinfo version
version: 3.3.0
[EOT](OK)
Send command: getinfo bootmode
nand
[EOT](OK)
Send command: getinfo nand
no find nand
[EOT](OK)
Failed to load blocksize for nand
When the process is finished I get this error.
Failed to load blocksize for nand....
