Posts by dankargo

  • OSCam-ICam For SKY IT, UK, DE

    Thank you so much! You were spot on, changing to the direct IP in the bouquet file has sorted it!

  • OSCam-ICam For SKY IT, UK, DE

    Quote from Chris230291

    Just guessing.

    You need to switch the IP in the bouquets on the second box to match the IP of the primary box.

    Thanks for the reply! Would the bouquet have changed in any way though when it was transferred from the main box, as client mode just downloads everything from the main box as is, so should already have the IP of main.

  • OSCam-ICam For SKY IT, UK, DE

    Has anyone had success watching icam channels via another receiver using client mode? I have oscam emu running on my SF8008 receiver (OpenATV) and the channels clear successfully. I have a VU+ Zero in another room running OpenVix that runs in client mode (with the SF8008 on standby) and it runs perfectly fine, with cccam channels and the like all clearing. But even though the icam bouquet has transferred over, they are the only channels that give me a black screen on the VU+. Strange thing is I can stream the icam channels just fine over VLC on a laptop but not on this other box. Do I need to install anything extra to get it working?


    Thanks

  • Unable to open AFN channels

    Thank you, unfortunately not. The openvix feed only gives me much earlier version of Oscam-emu.


    I tried manually installing 11517 and even though my receiver installed it fine, I couldn't reach the webif page (I checked oscam.conf and correct port was used as well as IP range). None of the config files were being recognised either.


    I've now reinstalled the Alternative Softcam Manager and im back to version r11507. Will this version be sufficient for BISS keys or does r11517 have a new format for them?

  • Unable to open AFN channels

    Thank you!


    I have tried to update Alternative Softcam manager by downloading the following file 'oscam11517_arm_emu' and adding it to /usr/bin/cam but now Oscam isnt starting at all, even after a reboot. I've obviously done something very wrong.

  • Unable to open AFN channels

    Hi everyone,


    Firstly I'd like to thank the forum for providing so much support to folk like me that is relatively still new to Enigma2 and softcams. I've just installed a 90cm motorised dish and using an Octagon SF8008 receiver on OpenVix. When setting up the box I installed the Alternative Softcam Manager which set up most things out of the box that I wanted such as Oscam-EMU and CCCam. However, I'm unable to open the PowerVU AFN channels at 9E. I've left the box on one of the channels for around half an hour but nothing has appeared yet, so I'm guessing something is not right.


    The Oscam version that was included in ASM was r11507, is this sufficent enough? These are the most recent entries in the log file if it helps. Do I need updated keys or should it auto roll?


    I appreciate any assistance :)


  • I cannot get Tandberg working :(

    Hi all,


    I have been trying to get Tandberg working for hours now. I have a Tandberg feed on 7E, I have the correct CW and PIDs which I added to SoftCam.key but it is just not showing. For months now I have never been able to get Tandberg working.


    I am using Oscam 11.273 with patch on a Vu+ Zero receiver.


    The Oscam logs currently show this - does it make much sense to anyone because I struggled :/