That is how I have it set up
Now I miss Jedixstream in the downloads.
It is back in order
with Dreambox DCC 2.40 I cannot access this software to modify ncam
Enigma2 not found!
does that work with another version of PLI software?
It could also be this one that is placed in your receiver.
The SIM card I had was similar to the one, but red
which froze, much more readable...many years ago, so I ordered the much higher-performance Japhar SIM that can be adapted to many Dream boxes.
It could also be this one that is placed in your receiver.
Do you perhaps know which SIM card is in your receiver? Otherwise, just take a look.
Because there might be another one in there as well.
And then, of course, this software isn't right.
and use this tool to flash your Dreambox with the correct software
Plenty of choice
and you always have to take software, in your case with 84d
if it is the first version of your receiver, of course
this software is not intended for the Dreambox 800SE V
is there a small black button on the back of your receiver
otherwise overvoltage off then keep pressing the button and overvoltage on
Just leave your receiver with the previous version for now
newer software isn't always better either
This is about a Dreambox 900 HD 4K
so software from a Dreambox 920 HD 4K will not work
because this is supposedly a newer version
I just did a software update
it was 188 pieces that it needed to update
surely that shouldn't be possible with newer OpenPLi 15.2 software
if I do a software update
that works. but then the receiver starts up again.
that works only partially. you see the yellow bar on the LCD screen. then it starts up normally further. you then get the blue screen with the name openpli release 15.2
and the red LED keeps blinking. so the receiver doesn't work any further now
it has been like this for at least 5 minutes with the red blinking LED
so now I am going to flash the original Dreambox 900 with a different one
and which skin do you use
hello hispanico66 have you looked at the link to set up your remote
try this
Yes I do. Now when I push rcu arrow down Channel list appear and work well. But when I change Channel or zap, It Is Always very slow.
is that on a free channel or is that also on pay channels
and which softcam do you use?
hello hispanico66 have you looked at the link to set up your remote
try this
I asked this question for the topic starter
because if the piccons are on the HDD your receiver will respond slower
if the piccons are on the flash memory .. then the receiver works more smoothly
Just a quick question
Where do you have your Picons stored? On the HDD or in your flash memory?
