Enigma2 load instead of the official firmware
A. Switch off the receiver.
B. Press and hold the OK button on the front panel.
C. Switch on the receiver.
D. After about 5 seconds, the display shows [Forc]. Release the Ok button. Then, press the Up button. The display shows [EN16].
E. Click OK to accept the burden. The receiver will restart automatically.
Charge place of Enigma2, official firmware
A. Switch off the receiver.
B. Press and hold the OK button on the front panel.
C. Switch on the receiver.
D. After about 5 seconds, the display shows [Forc]. Release the Ok button. Then, press the Up button. The display shows [SPAR].
E. Click OK to accept the startup. The receiver will restart automatically.
S8120 Gi Enigma2
1. Take the flash drive formatted in FAT32, you must have a partition.
2. In the root directory create an enigma2 folder.
3. In this folder, extract two files from the file downloaded in the link above (2 files: uImage and e2jffs2.img).
4. To install Enigma should be transferred to the receiver when the receiver is in Enigma boot mode, see explanation above.
5. Insert a USB flash drive into the receiver.
6. On the front panel, press and hold the OK button.
7. Turn on the receiver.
8. After about 5 seconds, the display shows [Forc]. Release the Ok button. Then press the right button. If all goes well, then the display shows [U LD]. The installation process will begin Enіgma.
The installation process will take about 5 minutes. If the update is successful, the receiver screen displays [SUCC] and the receiver will restart.
If it takes more than 5 minutes and the process is not complete, then something went wrong.
Of course, all types of flash drives are not recognized by the receiver, the manufacturer recommends using Kingston
Good luck!
