Download and use the
- DreamUP V1.3.3.12
For all models
Done! No response from the box, am using only COM Port as no IP is assigned to the box (checked Internet Router)
Thx for the advise
Connected with usb ? in the "service" port with mini usb.
Yes, of course... 
Download and use the
- DreamUP V1.3.3.12
For all models
Done! No response from the box, am using only COM Port as no IP is assigned to the box (checked Internet Router)
Thx for the advise
telnet using PuTTY
I am writing to you again...Open your eyes or take off your rose-colored glasses... and go to Johnny's forum here in this topic and look at the correspondence with a user who can be said to have had exactly the same problem.. https://jb8a8f8.com/support/in…900-uhd-only-led-red.785/
I am already looking there, Many thanks for the guidance...
Thanks Team, for your support, just small addition; the box was working fun but after a power cut it got stuck in halfway sartup, and then afte r several attempts it ends up to this status...
From which team was the image installed in your receiver before it crashed?
If am not mistaking , it was Open ATV image...
Display MoreIf you can still connect via Telnet then try entering the following commands via Telnet:
mount -i
mount -o remount,rw /
echo rescue > /proc/stb/fp/boot_mode
systemctl reboot
I really wish to be able to sent some command via telnet using PuTTY, But Unfortunately the only log/screen from PuTTY is the below, it doesn't allow me to write anything!
Thanks Team, for your support, just small addition; the box was working fun but after a power cut it got stuck in halfway sartup, and then afte r several attempts it ends up to this status...
The Oled is not lighting up.
I will follow the instruction and hope it will work.
Yes, right now am trying with another box power supply...from DM-TWO
Thanks Team for your suggestions, I removed HMDI cable and tried to get to rescue mode holding the red light button for 7 min, Unfortunately nothing happened...
The red light not blinking and as well the network green+orange light too.
Tried to find an IP using DCC-e2 search without success...
the below are from registered Optiflasher Pro Dmips software:
Power ON DB Device & Hold Button Until Rescue Mode [ESC to Abort]
Ballance Credits: 11
DM900UHD Detected !
Please Wait Processing...
I did wait for o hole night with no change!!!
The issue is that the box is not booting fully, or going to recovery mode either via finger on front redlight and not reacting to Telnet...
Hello Team,
I'm experiencing issue in rescuing my DM900UHD box, as of Now it is not booting and stuck on fixed Red Light no display on oled screen.
PuTTY gives me the below:
Dreambox DM900
AVS init...
AVS init OK
CPU 01
Dreambox DM900
AVS init...
AVS init OK
CPU 01
Dreambox DM900
AVS init...
AVS init OK
it keeps repeating indefinitely
Please help to rescue my box.
for info I tried with Optiflasher software and it gets stuck on "DM900UHD Detected! " only...
Best Regards...
Thx for the reply, all those options done without success. The orange & green network lights at the box network socket blinks one time and stops!!!!
that's why am suspecting the network driver fault.
Through Putty it says eth0 link is down.
Hi Team,
Could you please help with network driver for my DM900 to be reinstalled via Putty serial port under CFE mode.
as per my understanding the driver need to be with *.bin extension to be recognized as executable under cfe mode.
under rescue mode my box shows and error "eth0 link is down", and remains stuck in Waiting for DHCP.
best regards...
Dear Team,
Recently after a power cut my DM900 is stuck in half way of progress bar start up.
Network light not blinking, they lights when box turned on then went Off
Progress bar stuck in midle.GIF Rescue Mode No IP.GIF
When I try to go to recuse mode the box not loading IP address and stuck in Waiting for DHCP....
Please help to rescue my box.
The only communication access with the box is via Putty serial port. I'm not expert on linux commands, please help with commands to rescue my box.
Regards,
see attachements
