openbox x3 with no picture just flashing colours across screen is this tuner fault as i have vu duo works ok btw I updated fw without any change
Posts by jimmynewbie
-
-
would this cure INDENT UNINIT up on tv screen or can this be fixed
-
i also have IDENT UNINIT displayed on TV screen Also where can I get mini jack to RS232 adapter
-
what have you pcsc is it omnikey r u using stb or debian/ubuntu
a bit more details might help, i think i can see a problem or 2
let us know m8 and w will try to help LOLIt is omnikey and I am using ubuntu 10.4 many thanks for your reply
-
my_*** [pcsc] PCSC failed establish context (8010001d)
[reader]
label = my_***
description = ***2
protocol = pcsc
device = 002
cacheex_maxhop = 10
caid = 0963
detect = cd
nagra_read = 2
ident = 0963:000000
group = 1,40
emmcache = 1,3,2
blockemm-unknown = 1
blockemm-g = 1
saveemm-u = 1
saveemm-s = 1
lb_weight = 101
auprovid = 000963can anyone see what the problem is here
-
the box shows no signal on TV .I replaced the tuner no difference.I then upgraded to the latest firmware and the box did not detect any channels on blind scan. Any thoughts on the problem.
Many thanks -
lobster.ou has all files for download
-
you assume correctly open box s10 I aquired these not working to attempt to revive them.In some UK forum they were saying ic chip 4814 was defective that a better IC chip was 4844 many thank for your replies I will check through Aliexpress I just did not fancy there postage delays
-
psu looks as if its dead where can I get replacement board
-
I have blackhole image and only one tuner works .I am sure I read somewhere about the same problem but I cannot find it.
-
thanks for the post but I have already done that and the box clears the net setting and the server settings .I think that the problemis the the mac address is gone .I also upgraded the image via usb.Icould not connect to the box via the the rs 323? at the rear of the box. Any thoughts greatly appreciated Latest update the pcb had come free of the motherboard and I now have lan and mac address .It also retain ccam settings but still does not decode
-
I followed the network setting PDF but I think that because the mac address has gone the setting that I put in are not seen on the router and when the box is powered off the settings clear .I am trying all ip address starting at 1 and I am at 100 at the moment.That doc tell me if the box is clear check lna ? any ideas greatly appeciated
-
in network settings it is blank and the mac address is empty. The manual tells me to check the LNA.The website that I got the pdf file was Lobster .OU what does LNA mean and how do I get it.
