Posts by Petrik25

  • Slow/No loading chanels, freezing and other problems

    • We don`t advertise or promote any illegal Cable, Satellite or IPTV streaming services.


    that is undersanable


    I am trying to learn to read a osccam log, and found this line error, what does it actually mean? it seem error number 92, is there a list of error numbers?

    "(net) Setting IPV6_TCLASS failed, errno=92, Protocol not available"

  • Slow/No loading chanels, freezing and other problems

    Thanks for pointing out privacy issues, didn't even think about IP addresses.


    So the faults are all over. Ok. What would that mean for me. Is there anything I could do from my point of view, from my end, to improve, change some settings, tweek it?


    Or are all those faults server related which of course, is out of my reach. Or could they be related to my connection? My ISP is using PPPoE protocol to deliver internet service to my house over fibre optic cable.

    Could that have some influence on my issues?

    Someone has mentioned to swap oscam for cccam, but if it is server related, it wouldn't make any difference, I think.

    I apologize if it is not allowed, can you or someone advise good, tested, reliable server for lines?

  • Slow/No loading chanels, freezing and other problems

    Hi all,I am new here so pls take it easy on me.
    First I want tell you is what problems I have I will need help with, and them about specifics.
    When I change channels it takes forever to load it/change it, I meant like around 5-30 seconds, and sometimes it doesn't even load or loads only sounds and when it does it freezes within a minute.
    As you will see from below I do have quite a few lines to choose from but I noticed P lines doesn't load at all, it just stopped loading. Only change what happened was my ISP sent me new router which I have swapped( old Technicolour, new Eero)
    When I looked at oscam log I have noticed P lines do not load and it reports some error. I do not understand it, it's too techy-techy for me, I will attach it.
    So my questions
    1, Can someone help me to sort that slow loading and freezing
    2, those P lines are meant to be faster then S line, so make them work again.


    My equipment:

    Vu+ Uno 4kse, connect to router via cable, fibre optic house connection (500 up and down)

    open pli (9.0 release vuuno4kse 20231120

    oscam (git10633+13a0754-r0.0)

    satelite dish pointed at Astra 23.5e (Skylink Svk/CZ)

    PS:i have removed user name and password from oscam.server

    if it is in wrong topic, i appologise, pls move it correct one.


    V U+ Uno4KSE FBC DVB-S2XVU+ Uno4KSE FBC DVB-S2XVU+ Uno4KSE FBC DVB-S2XVU+ Uno4KSE FBC DVB-S2X VU+ Uno4KSE FBC DVB-S2XVU+ Uno4KSE FBC DVB-S2X

    VU+ Uno4KSE FBC DVB-S2X