Hi,
if you had a working LAN...disable it first,
then go to the active Wi-Fi and find your favorite. You can then save it, but I recommend...disable DHCP...it should be red...and add the DNS manually.
Posts by piterfree
-
-
I found the libraries in other software that I had saved with DreamExplorer,
!!!...thanks for the new software.
everything perfect tested...with some small plugin additions everything solved...Thanks
vedio now I see the movie I can stop fast start and rewind...this was important for me on E2iPleyer.
-
Hi,
I tried installing it with the LinuxSat panel, but it didn't work either via Telnet. I'll try again with the plugin.
I had it on the hard drive copied from another PLI, but it didn't work...it gives an error.
-
Found another problem,
Is it possible to add (ServicaApp) to the feeds?
I tried adding ServiceApp to use E2iPlayer,
but to no avail. The script works with other software like E2iPlayer.
-
HI,
I got the official Tivùsat device, but I would like to use the card on my Vu+ Solo2. Is the green card compatible with OSCam 2.24.10-11842?
ThxNO
-
-
I copied the files from another PLI, but the result is the same.
I replaced the
display
sckin_default folder.
-
my favorite and I don't have the solution
I also uninstalled the basic one and after 4 skins do you think it is the skin that needs to be modified or is it the software that is fixed without the LCD part...??
-
I used the Aglare skin
which has its own system and I added two different models.
I changed 3 skins
It's the soft one that's designed without the LCD option.
-
-
I have a problem on LCC display there is no possibility to have the picons..!!
how do I add...??
-
How can I be on torrents...???
It doesn't seem feasible to me...!!
-
If you installed new software,
that skin no longer works, as I've already mentioned.
I switched to the older soft
skin Aglare ok 100x100
-
My 920 is fine.
If you want to at least restore the original feeds, you can find them in the location I circled in red and replace them with those in
etc/opkg
see the routes
-
Screenshot_2025-12-13-14-36-04-918_com.android.chrome~3.jpg
What a mess!
Who changed this feed?
DM 920 is ARM.
Not MIPS.
-
I inserted a switched off card into the rear reader and it has been stuck for 3 weeks, see the photos
-
You just need to check the TVsat card reader to see if it's the right one.
With OSCAM, go online and check if it reads the card's ATR.
If it doesn't, change the reader.
Reader = 0
Reader = 1
If it reads ATR, it takes 2 minutes for it to update.
-
In post #26,
I've attached the backup
to send to DM 800se Clone Sim2.10
And you're still asking how to configure everything.
There are tons of TVsat configurations for Oscam available online.
-
you need to check where you put the front reader card above or below
test via web...8888
-
There's the software...2025-12-11-11h34m-dm800se.nfi
+ssl 84d...if it doesn't restart, the decoder must be sent with the COM port if it causes the crash.
