Posts by spok

is it normal that upper_card and lower_card are OFF ?

Thank you. I think I start to understand a little how it works...

I have followed the instructions provided in the thread you pointed at.

I have changed the following parameters

Include ECM in HTTP streams              - NO
Descramble HTTP streams                  - YES
Descramble received HTTP streams         - NO
Load unlinked userbouquets               - YES

to YES for the 4.

I have copied the 3 provided .tv files in /etc/enigma2 and then added these lines at the beginning of the bouquets.tv file

#SERVICE 1:7:1:0:0:0:0:0:0:0:FROM BOUQUET "userbouquet.sky_UK.tv" ORDER BY bouquet

#SERVICE 1:7:1:0:0:0:0:0:0:0:FROM BOUQUET "userbouquet.sky-DE-icam.tv" ORDER BY bouquet

#SERVICE 1:7:1:0:0:0:0:0:0:0:FROM BOUQUET "userbouquet.sky-it-icam.tv" ORDER BY bouquet

and now I see these 3 new bouquets at the beginning of my channel list but still when I select a channel of them still it doesn't really work.

Sometimes it works for some seconds then it freezes.

I have entered the following under CCcam section. Some channels like RTL, SAT.1 etc. work but other channels like Sky Cinema doesn't work :-(

What do you mean by "make channel settings, for ICAM_DE" ?

[reader]

label = xxxxxx

protocol = cccam

device = xxxxxxxx,yyyyyy

user = xxxxxxx

password = xxxxxxx

group = 1,2,3,4,5,6,7,8,9,10,64

emmcache = 2,1,2,1

cccversion = 2.0.11

ccckeepalive = 1

cccmaxhops = 2 # dont use higher than 3 !!!

disablecrccws = 1

cccwantemu = 1

blockemm-unknown = 1

blockemm-u = 1

blockemm-s = 1

blockemm-g = 1

audisabled = 1

services = !powervu_fake,!tandberg_fake,!biss_fake,!afn_fake,1708:000000

disablecrccws_only_for = 1709:000000;1708:000000;1811:003311,003315;09C4:000000;0500:030B00,042820;0604:000000;1819:00006D;0100:00006D;1810:000000;1884:000000;0E00:000000

how should I configure my reader in ncam.server to make sky deutschland work ?

Another question : where is the Open Multi Boot ???

found it

Hi,

I have installed last version OBH 5.3.009 and I have noticed something that could be a bug...

This concerns the configuration of the tuner.

I'd like to connect my tuners like that : A <-- C <-- D <-- E

I can connect Tuner C to Tuner A and Tuner D to Tuner C but impossible to connect Tuner E to Tuner D

The interface allows only to connect Tuner E to Tuner A

Furthermore, it's even impossible to make no connection for Tuner E (impossible to change "Connected through another tune" to No").