I installed the new vix apollo yesterday work's fine.
Posts by ronnie11
-
-
Yes left it running, Switched box on & off no problem's up to now finger's crossed..lol
-
Finally cracked it, I downloaded enigma2-plugin-cams-mgcamd.1.35a_1.0-r3_mipsel.ipk ftp to temp folder/installed local extension on box/started Mgcamd/enabed auto start & it work's perfect... Hope this may help anyone with same problem's as me.
-
It work's till i switch the box off then nothing.
-
id start over & uninstall mgcamd - reboot
then reinstall it again - reboot edit details & restart mgcamdmgcamd 138c is the version you want m8
Well ive done what you said deleted everything, Reinstalled mgcamd but nothing working so i reinstalled CCcam all channel's work, Now the strange thing happen's when i disable start up on CCcam & enable start up in mgcamd it work's ??
-
Thank's for all the help will give it a go tomorrow.
-
Im useing openvix-helios .017 Which mgcamd do you recomend currently on mgcamd 138c.
-
Inspiral, Setting's are exact as you say, Master G Mgcamd is set to enabled at start up ?
-
Still not working, Pulling my hair out now...lol
-
I was useing CCcam but was told to use mgcamd which ive done, Mgcamd work's sometime's Only log file i can see is cam.check log which read's Couldn't find Mgcamd-1.38c running, Starting Mgcamd-1.38c
2014-06-03 18:42: Timer Check Enabled
2014-06-03 18:42: Couldn't find Mgcamd-1.38c running, Starting Mgcamd-1.38c
2014-06-03 18:48: -
Done the above all channel's working, Do i need to alter the 04 back to 02 ? Ftp into temp folder but cant find any mgcamd log's ?
Changed the 04 back to 02 switched box off still nothing.
-
Anyone help, Ive switched box back on today & mgcamd isnt working, Tried restarting it & reboot box but nothing.
-
Just an update on the above, I stopped mgcamd then restarted it rebooted box now it's working...strange.
-
Had the mgcamd runnung ok for a couple of day's switched box on today & getting no channel's, Anyone any idea's.
-
Cheer's fatbob, That sorted it.
-
Thank's will give that a try
-
Tried all the above but still no channel's, Am i missing something. After the N do i put a dash or equal's
-
I rember reading somewhere when i enter my nline i have to put space's somewhere is this correct.
-
I have a Nline do i need to alter it to work ??
-
Thank you will give it a try later, Been pulling my hair out yesterday trying to do it.