VU+ Solo2 tuner config

There is 1 reply in this Thread which was already clicked 1,096 times. The last Post () by codar.

    Hi, tell me please what is proper tuner config for sigle cable connection? I have 4 LNB's with Diseq and only one cable to receiver. Manual says that single cable should be connected to LNB2 input. But if I do so then there is 0 signal strength. Only when cable is connected to LNB1 input everything is working. I tried to set up both tuners with the same settings and I also tried loopthrough for tuner A. I'm using last BH image.
    Ideas? Thank you.

    Setup the tuner that the cable is inserted into (don't think it matters if its a or b as long as its enabled but go with b if the manual states it).
    menu/setup/service searching/tuner configuration/select tuner B
    Configuration mode :simple
    Mode disceq A/B/C/C
    Port a should point to the satellite connected to port a(or 1) on your diseqc switch.
    Port b to satellite on port b (2 ) on switch and so on and on..

Your resource for Enigma2 tuner configuration

Find tutorials and support for setting up DVB, advanced FBC, and USB tuners for satellite, cable, and other signal sources. Master your receiver's tuning capabilities. Find dedicated support and guides to configure DVB, FBC, and USB tuners for optimal satellite, cable, and digital TV reception.