Has Anyone managed to get a mgcamd for vo solo 4k with vix image working??
thanks guys really want to use this image but at the moment im stuck with blackhole because that has mgcamd
mgcamd for vo solo 4k with vix image
- enrico001uk
- Thread is marked as Resolved.
-
-
Its only working on blackhole so far.. You are not stuck with blackhole, oscam will do everything mgcamd does and more.. If you need help switching to oscam just ask..
-
Oscam runs bad in Solo 4k
Mgcamd is much faster and stable if not using a Card -
Oscam runs bad in Solo 4k
Mgcamd is much faster and stable if not using a CardThat may be your experience, but i have no issues using a real card or server with oscam 11196..
-
Give the attached file a try.
-
Ftp it box and installed through extensions does not not show anywhere
Vix image
-
The binary has been placed in /usr/bin/ Openvix uses /usr/softcams/
Use 7zip to extract it twice,
Transfer the mgcamd file /usr/softcams and change file properties/attributes to 755. It should show up in softcam manager then. You may need to transfer the config files. -
I fixed the ipk, give it another try..
-
Loaded OK thanks Master G:.
Put 2 clines into ccamd list and nothing happens.
The same 2 lines are put into CCcam to oscam converter and transferred as oscam server file work ok.
So i know it not the lines what am i doing wrong.
The files i have are:
ccamd.
mg.cfg
newcamd
softcam
-
same boat mate
-
Best Way is someone load a Backup Image with working Mgcamd for OpenATV or Vixx in this Forum
-
I have got it working.
Changed G TO (33)
And in in the mfg.cfg changed from mips to arm not sure which one got it working
-
got this working guys
but mgcamd wont autostart
got to go to softcam manager and restart it
anyone any idea
cheers -
Display More
got this working guys
but mgcamd wont autostart
got to go to softcam manager and restart it
anyone any idea
cheersIs there a green tick in the box beside where it shows the cam??? press the blue button on your remote to activate the cam..
-
I have got it working.
Changed G TO (33)
And in in the mfg.cfg changed from mips to arm not sure which one got it working
where in the mg_cfg did you change mips to arm ? -
Display More
got this working guys
but mgcamd wont autostart
got to go to softcam manager and restart it
anyone any idea
cheers
how did you get it working ? -
where in the mg_cfg did you change mips to arm ?
05 openbox
# 06 dreambox/arm#I loaded the files all again g had been changed before after i altered the above it started to work.
Upddate.
It also stops with me say i switch channel i have to restart it
-
Please try this new ipk lads and give feedback..
-
Loaded latest ipk nothing working
- - - Updated - - -
It's working my fault loaded wrong file
-
And for OpenATV 5.2 ??
MGCamd Support Forum
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!
