how to mount usb

If I remember when I used Openpli I installed mount manager.Menu/press green button.I think mount manager is in the downloads.Download it and reboot.You'll now have mount manager installed.Just setup your device in there

with DCC write this command on telnet

mount /dev/sda1/ mnt/hdd "" if you used only usb ""
or
mount /dev/sdb1 /mnt/usb '' if you use hdd and usb '''

Quote from nounou2004

with DCC write this command on telnet

mount /dev/sda1/ mnt/hdd "" if you used only usb ""
or
mount /dev/sdb1 /mnt/usb '' if you use hdd and usb '''

Please, what is different between first and second commands?

Is it first or second for HDD inside receiver internal
?
And which is a command for outside receiver in USB HDD external?

Poslato sa Huawei P8 lite

mount /dev/sda1 /mnt hdd

hdd or usb if you use only usb

mount /dev/sda1 /mnt/hdd

if you use internal hdd and usb

mount /dev/sda1 /mnt/hdd

and

mount /dev/sda1 /mnt usb

if you use internal hdd , external hdd and usb
with dcc you create in media , a new folder => hdd2 et you mount it with

mount /dev/sda1 /mnt/hdd2

Quote from nounou2004

with DCC write this command on telnet

mount /dev/sda1/ mnt/hdd "" if you used only usb ""
or
mount /dev/sdb1 /mnt/usb '' if you use hdd and usb '''

What is DCC

And to confirm if I am using a external hdd via USB as I assume I have to do on the Vu Solo SE V2 I use the above command.
And this is done while the box is fully up AND hdd connected?
Do I need to reboot or anything once this is done?
Will this then display in mount manager?

Sent from my SM-G935F using Tapatalk