hi guys
i have vu+solo4k twin sat with cable tuner installed
running latest openxix
the tuner in the box works but frezzer and puxalates a lot so added my usb turbo tuner but get tuner failed
any ideas
cheers
hi guys
i have vu+solo4k twin sat with cable tuner installed
running latest openxix
the tuner in the box works but frezzer and puxalates a lot so added my usb turbo tuner but get tuner failed
any ideas
cheers
Have a look at your signal strength/quality.
Are you using it cable (dvb-c) or terrestrial (dvb-t/t2)?
If it is for terrestrial, you may have a problem with your aerial installation or cabling/rf plugs etc.
Your signal strength/quality should tell you this (if it is poor)
hi
dvb-c
98℅
98%
im useing oscam
could configs be wrong
sky is fine
but cable is un watchable
Do you get the Freezing and glitching on FTA cable channels as this would point to a signal/cable problem, could even be too much signal overloading the Tuner
fta does glitch / freeze but not as bad
i get around 99℅ signal and same again strenth
As i stated previously sounds like an issue with either cabling/Connectors or you need to add an attenuator or a forward path type to solve the problem, My Onboard Dual DVB-C/T/T2 tuner on the 4K has zero problems although i do have the equipment and parts to remedy any problems for myself
i have pluged direct feed into box
fta does not glitch
can not check premium channels as need to split signal
as soon as i split signal the fta becomes blocking and frezzing
noticed sgr is 99% to 0% and back again
have tryd 3 different splitter all do same
added attenutor close to box
still the same
anymore ideas guys doing my head in now lol
cheers
to all so far
What do you mean by splitting the signal?
i have 1 feed coming into house
i have a 2 way spliter connected to main feed which splits the signal to my solo4k tuner and to bb
I could be wrong but I always thought splitting a digital signal was not
very successful. Try taking the splitter out and run the cable ditect to
each box in turn and see if that stops the freezing and glitching, it's
worth a try.
hi
i am talking virgin cable not satalite
splitting vm feed is normally fine mate
splitting sat is a no go
Next time I will read the post more carefully, hope you get it sorted.
you have found the problem yourself when you take a direct feed into the DVB-C tuner and omit the splitter as you say your FTA channels are fine with no sign of freezing or breakup which means you need some form of cable booster.
As soon as you split the signal you are taking away XX.db out of the incoming signal which the tuner cannot handle, Hope your not using a full frequency splitter ie: 5-2400mhz as these also can create problems
Ideally if you do not have a spare official VM splitter then ebay Tratec 2 way splitter for a 5-1000mhz one.
Also log into the VM superhub advanced section and post a screenshot of your power levels
screen shot attached
hello guys
i have latest openvix image
sat tuner is fine
i have installed cable tuner and also tryed my turbo tuner
all low freq just block and glitch on both tuners
even fta freeze a bit
snr goes from 89% to 0% then back again
its just unwatchable
anyone any ideas
i have tryed 2 splitters both do same
Don’t have an account yet? Register yourself now and be a part of our community!