hi guys,
so im trying to start up....so far ive installed Ubuntu, Oscam and Cccam.
everything is fine... ive ordered a Omnikey 3121 card reader
is there anything else i need?
thanks
hi guys,
so im trying to start up....so far ive installed Ubuntu, Oscam and Cccam.
everything is fine... ive ordered a Omnikey 3121 card reader
is there anything else i need?
thanks
A card and the correct configs for oscam.
Port forwarding in the router to allow peers to connect to your server.
A dynamic hostname. Setup auto updating of hostname in router or on the server.
Sharing partners.
im struggling with the port forwarding.... its asking for source point and destination point
what should i put in there?
The port you should be opening is the sharing port of either [cccam] or [newcamd] in oscam.conf (don`t use the default ports, change them to your own)..
Source point and destination point ip address will be both be the same, your server`s ip address.. Same applies for your ports..
Which router are you using ?
its the virgin hub 3.0 ( the white one )
cheers mate sorted that. in oscam in the status tab i dont have a server it just shows Proxies 0/1 label cccam etc etc??
It won`t show any readers or proxies until you add your card or a share into oscam.server as a [reader].
what card do i need?
thanks for your help master g
Which card were you going to setup on the server ?
Were you expecting to card share without one ?
i will be using a sly card
Is it a white or red card ?
If white has it been in the official sky HD decoder recently ?
Red one m8
Look here -> Oscam Configs For SKY UK CAID 0960 Red Card
The configs you should be using are "Sky UK Caid 0960 Red Card Oscam & CCcam Config Omnikey.rar"..
cheers mate! so when my card reader arrives what are my next steps to getting up and running?
FTP the configs i linked.
In oscam.server the parameter device = 0 may need to be changed to device = 1 or 2, 3 until you find the correct port the omnikey is using.
Convert the serial number from beneath the official decoder into a boxid / boxkey. Add this to oscam.server, parameter boxid = (example, boxid = 12345678 with no spaces)..
Show us an oscam log from startup and after viewing some channels if you have any problems..
thanks again master g!
Is it a white or red card ?
If white has it been in the official sky HD decoder recently ?
Hi Master G, Can I ask why you asked that if it was a white card and it had been in the HD decoder recently ?
Because the white card will be locked / paired to the official decoder and won`t work in any thrid party receiver or card reader.. You would then need to pair the card again to an old standard definition model..
Don’t have an account yet? Register yourself now and be a part of our community!