Hi,
I have a DM800se clone with A8P sim (motherboard D11)
Lastest open pli 4 image installed.During the work it lost communication. Only some red(4) leds in the receiver and one green on the tuner nothing on the display.I have just purchased a new power supply
and replaced it.Replaced my sim A8p also, but nothing happens and still have nothing on display.I tried to dreamup to establish communication according to the instructions but I can not connect.
No idea what is wrong. Any help is welcome
Dm800SE Fault
- kaktuscar
- Thread is marked as Resolved.
-
-
-
Thank you, but unfortunately it does not help in my case. -
use the original image no need for clone image.
http://linuxsat-support.com/view.php?pg=openpli -
Dream logo doesn't appear on the display, same goes for ip address so that's why i can't install any image.
-
you need driver before you get connection first one window 7 second window 10 reboot pc & your good to go
-
I have windows 7 64 bit with installed drivers u mentioned.
Dreambox recognizes the comp port which computer gives him.
I used universal DreamUP_1_3_3_12 and crossover cable but nothing happens. Even though i entered ip addresses and checked use network, it doesn't connect to my dreambox. -
sorry i use drivers for 86 you need to this h+++s://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx
i misunderstood you i thought you had 800 se , you need mini usb cable not crossover cable -
sorry i use drivers for 86 you need to this h+++s://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx
i misunderstood you i thought you had 800 se , you need mini usb cable not crossover cableI used mini usb cable and lan cable. I didn't have any ideas left so i was googling and i read somewhere that i should try crossover cable, i tried it and its still not working.
Your support hub for the Dreambox receiver.
Help, firmware and downloads for the Dreambox Enigma2 satellite receiver. Ask about setup, channel lists, plugins and troubleshooting.
