Hi,
I have a DM800se clone with A8P sim (motherboard D11)
Lastest open pli 4 image installed.During the work it lost communication. Only some red(4) leds in the receiver and one green on the tuner nothing on the display.I have just purchased a new power supply
and replaced it.Replaced my sim A8p also, but nothing happens and still have nothing on display.I tried to dreamup to establish communication according to the instructions but I can not connect.
No idea what is wrong. Any help is welcome
Dm800SE Fault
- kaktuscar
- Thread is marked as Resolved.
-
-
-
Thank you, but unfortunately it does not help in my case. -
use the original image no need for clone image.
http://linuxsat-support.com/view.php?pg=openpli -
Dream logo doesn't appear on the display, same goes for ip address so that's why i can't install any image.
-
you need driver before you get connection first one window 7 second window 10 reboot pc & your good to go
-
I have windows 7 64 bit with installed drivers u mentioned.
Dreambox recognizes the comp port which computer gives him.
I used universal DreamUP_1_3_3_12 and crossover cable but nothing happens. Even though i entered ip addresses and checked use network, it doesn't connect to my dreambox. -
sorry i use drivers for 86 you need to this h+++s://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx
i misunderstood you i thought you had 800 se , you need mini usb cable not crossover cable -
sorry i use drivers for 86 you need to this h+++s://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx
i misunderstood you i thought you had 800 se , you need mini usb cable not crossover cableI used mini usb cable and lan cable. I didn't have any ideas left so i was googling and i read somewhere that i should try crossover cable, i tried it and its still not working.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!