Solo2 Jtag

Quote

About the Jtag Solo2 original...

Hardware/software needed..
1. Vu+ Solo2 receiver for the connection to the P701 connector.
2. CY7C68013A development board.
3. Broadband Studio 3 software with the the bcm97346 cpu drivers.
4. CFE bin file.
5. And (of course) a windows computer etc.

First install the,
1. Broadband Studio 3 software.
2. Then connect the development board with the usb cable, turn it on, driver install will follow.

It will do this driver installation twice.

3. Switch off the development board, Connect the Gnd/Sda/Scl wires to the P701 connector.
Mb P701: Scl -> Cyb. Scl
Mb P701: Sda -> Cyb. Sda
Mb P701: Gnd -> Cyb. Gnd


Howto connect step 4.
4A. Start up the Broadband Studio 3 software,
4B. Choose the Bcm97346,
4C. Turn On the receiver,
4D. Switch on the development board.

Or when it not connecting,

4A. Switch on the development board,
4B. Turn On the receiver,
4C. Start up the Broadband Studio 3 software,
4D. Choose the Bcm97346.

And when all is correct, you should see the connection to the Bcm97346 cpu but when not, switch Off the motherboard, and turn it On again.
After this you must see a connection, if not, then you have not a good working motherboard or development board or some other cause.


5. Choose Flash explorer, choose Samsung K9F1G08UOA, press Refresh, Browse to the Cfe file and press Start.


When finished, disconnect the development board and upload a image file on the regular way by Usb.

Download...
The Broadband Studio 3 software with the the bcm97346 cpu drivers and pdf instructions can be downloaded from mega.nz, file is 84.3Mb.

An Cfe bin file can be downloaded from beneath, it's for the original, but can also used with clones because I've tested it on a solo2 clone with a new nand flash chip.
And also included the Usb drivers download, normally it should be already installed after the installation of the Bbs software, but just in case you needed.

Display More

Attached Files:

Org-Solo2_CFE.zip

BcmUsb.zip

thx to Johnny B.