hello all,
my vusolo went down tonight and stuck on boot of pil4 i have various back ups in the hard drive and can access the vu with telnet and ftp but cant get into webif, could i run a backup of the hard drive from telnet ??????
hello all,
my vusolo went down tonight and stuck on boot of pil4 i have various back ups in the hard drive and can access the vu with telnet and ftp but cant get into webif, could i run a backup of the hard drive from telnet ??????
Why don't you copy the backup to PC and flash by USB?
tryed that but wont move of openpli start screen
does not seem to want to read the usb and i have tried 2 now the last stick was one that i usually hold epg on so the box is used to it, i wiped it fat32 and loaded full backup from hd but still at the openpli splash screen
good morning , ok i think u need to reflash new image . but u need to disconnect hdd , hen u should be to put backup from hdd .
if is bugs in hdd or not good plugins is beterto setup again from the scratch .
is there not a way to telnet into box and run backup from hdd ? the hdd is inside the box,
not sure ??? but try this umplug hdd and reboot box with no hdd as i think is plugings corrupt in hdd
i will have to take the cover off and unplug the hdd from its mount, surley there is other option
The HDD is probably the problem buddy.
When you try to flash via usb its also possibly reading the backup.
Try disconnecting the HDD, flash a new image, connect HDD again and retrieve the backup.
Remove the backup from the HDD so it doesn`t conflict again.
Now reflash the backup.
thanks master g and joksat, ive managed to get back up and running again, as you both commented i opened the box and desconnected hdd then flashed another pil4 image, then connected the hdd again and downloaded backup suite and extracted the last back up i made acouple of weeks ago, thank you for prompt advice boys,
happy lacierva:)
Don’t have an account yet? Register yourself now and be a part of our community!