There are no other FTA ones on Cable. The others are encrypted.
Just because some channels are FTA on Satellite, it does not mean they are also FTA on Cable.
There are no other FTA ones on Cable. The others are encrypted.
Just because some channels are FTA on Satellite, it does not mean they are also FTA on Cable.
Mate first thing to do is upgrade to open atv 6.1
you would be better trying to install wooshbuild or ipab mate
Mate first thing to do is upgrade to open atv 6.1
Thanks buddy it worked. But I have less chns in lists
if you dont know someone that will share there card with you you can install the free cccam plugin to clear the channels
you will also need a softcam installed
What does this mean guys ? I’m still messing around with it.
It means you are not able to lock onto the frequency set for the selected area in ABM. It can be a number of reasons:
Wire disconnected.
Faulty connection.
Faulty splitter
Fault wiring
Wrong area selected
Signal issues
Incorrect setup of tuner
Will have a look again later I think it’s faulty connection.
How much channels do you lot get when scanning for vm channels ?
It depends in what area you are in and what frequencies the xml file has listed. Pure areas only have their own channels. in Ex-CW and Telewest areas, a scan will find dead channels that do not work. So the results are mis-leading.
You should be methodical in your approach.
1. Have you connected the cables correctly.
2. Do you know what system you are in? Pure NTL, ex-CW , Telewest
3. Do you know for definite what you net Id is
4. Have you set your tuner/s correctly. In tuner config,
If a hybrid tuner ensure you select the correct mode. Cable or Terrestrial
You should select UK, your cable area type, otherwise use all systems. You can leave net ID as 00000. It does not matter in the UK
5. Most dual tuners have only one signal connection port, there is an internal splitter. You must set both tuners.
Scanning/Bouquets:
How do you want to "scan". You can:
A. Use AutoBouquetsMaker which will "scan" and place the channels in the correct order for you. This depends on you having done the previous steps correctly and not have any signal/cabling issues. You must select the correct Net ID in the area selection. If the first five channels in cable entertainment bouquet work, you have the correct NetID
B. Manually scan one transponder then use AutoBouquets Cable. Unless in a pure area, you must use correct Net ID too.
C. Perform an Enigma2 scan and manually arrange the bouquets yourself.
For manual scan, if you have done 1-4 correct, select provider and complete scan. In an ex-cw area you should find about 600 channels although a significant portion of these are dead channels and the results vary depending on test channels.
Can you help me on teamviewer please I’ll pay u something money ?
Helped him using teamviewer, for free. He can donate to forum if he likes
Issue was at point 3. Wrong NetID/area used in ABM.
Unfortunately, OP thinks there will be more channels than there are. He is in a Pure area, so he will not get the dead channels.
For EPG, make sure you enable "Virgin EPG" in the EPG options.
Thanks for the help abu baniaz & johndeere88 for free for coming on teamviewer last night and helping me out. Yes I did expect more channels I thought I will get more than sky but unfortunately this is the max limit for vm ones I thought other people were receiving more than me but not. I’ll donate now to this forum. Thanks all?
We can close this thread now.
Don’t have an account yet? Register yourself now and be a part of our community!