NCam 5.2: Diablo Wifi 2.6 and Newcamd protocol

There are 6 replies in this Thread which was already clicked 3,242 times. The last Post () by sage79.

    Hi,


    i connected my Diablo Wifi 2.6 to ncam 5.2 with newcamd protocol but i have this error message:


    "WARNING: setting tcp keepidle to 10 minutes for bugged diablo wifi"


    (EDIT: Diablo stays connected few seconds and then disconnected)


    Is it a bug? What can i do?

    Edited once, last by sage79 ().

    OK for error message but I don't think that it can influence connection of DiabloWifi. With the same configuration (of Diablo and router) oscam works while ncam (according to me better of oscam) after few seconds give me block image even if it continues to be connected.

    Also changing port diablo run for few seconds and then black screen (but always connected). With same configuration in oscam all ok so i don't think that is a configuration (ncam or router) problem....


    [newcamd]

    port = port@caid:ident

    serverip = 192.168.X.XX

    allowed = 127.0.0.1,192.168.1.1-192.168.1.255

    key = 0102030405060708091011121314

    keepalive = 1

    Edited 2 times, last by sage79: PROBLEM SOLVED There was this parameter checked "mgclient = 1" instead of "mgclient = 0" so diablocam wifi blocked itself after few seconds. ().

Your resource for Ncam softcam.

Find configs, tools, downloads, and community support for setup, optimization, and card/server management. Master modern card sharing with Ncam. Access configurations, tools, downloads, and dedicated support for efficient Enigma2 server/client setup.