How To Flash A VU+ ZERO 4K Linux Enigma2 Receiver

7) If in doubt…

then what?!

Remove usb device

Turn off box

Turn on box

Thats it

Quote from ferysery

7) If in doubt…

then what?!

...wait a full 10 minutes then power down; remove usb stick; power up.

thank you i will try this

Hello, I have a problem with the decoder

as always, I wanted to upload an image, I turned off the decoder, inserted a pendrive and then turned on the decoder and to my surprise it does not want to turn on, the front LED light does not light up, the decoder seems to have died, I do not know what is the reason for this ;( please help

you seem to have the same problem with all your different decoders

I wrote this in two different forums

I have two decoders vu zero 4k and vu uno 4k se and the same problem and I don't know if it's the pendrive's fault I have 8gb I've always used only the same pendrive and at the moment the decoders don't want to start ;( I'm devastated

I'm currently using open atv but that's what I do, tomorrow I'll have these decoders and I'll try on a smaller pendrive, below 8gb

do you think it will help, since the decoder doesn't even want to start and after trying to turn it on, even the front LED light doesn't turn on at all?

or could it be that, for example, the system, processor or other part in the decoder has simply failed?

Quote from jenseneverest

Quote from maarcin80

I'm currently using open atv but that's what I do, tomorrow I'll have these decoders and I'll try on a smaller pendrive, below 8gb

do you think it will help, since the decoder doesn't even want to start and after trying to turn it on, even the front LED light doesn't turn on at all?

or could it be that, for example, the system, processor or other part in the decoder has simply failed?

you not explaining the full story. The question is how do you manage to have 2 decoders in the same state.

Why do you not have these decoders, are they yours or not ?

Display More

The decoders are my friend's friend who has two decoders to which I was to upload a new image, they asked me to do it, I went and uploaded it and to my surprise after installing the pendrive and starting the decoder, the decoder did not start, I had a problem with one decoder so we tried the second one and there was the same problem, that's why I'm looking for a solution here, before I maybe take it to the service but they are out of warranty but maybe in my city I'll manage to find someone who will know the cause, but I preferred to ask smart people here on the forum, maybe they will help me

try changing the power units.

Unfortunately, it doesn't help, I insert a pendrive, turn on the decoder and it doesn't start, the front LED light doesn't react:( it's dark, it's just dark

have a feeling that you used the wrong image for flashing boxes . Both boxes should simply work if you do not insert usb stick with previous image in it. IF so then the bin will be happy