Hi,

I have 2 decoders. First decoder (living room) has card (server) and the second (client) is in my bedroom. Last decoder (client) not send emm to first decoder to update card. AU is on but it is not going to ACTIVE modes.

Which is parameter that lets to go in active mode?

ncam.user (server)

user = user

pwd = password

caid = caid

uniq = 1

au = [label]

group = 2

ident = caid:provid

keepalive = 1

Hi,

I have tried an old version of NCam "NCam_1.9-r1" official (so I think also with corresponding NCam compiled and patched by READ) and all work perfectly (from ON to ACTIVE) without any problem. It is a problem born with following NCam version.

I have tested old NCam for curiosity. Up to NCam 8.1 is all ok (from on to active). After this version au not change in active mode.