1. You have to buy NOR chip and modchip (ca 10Euro = 40zł), both are allready programmed
2. Then you need to replace old flash chip with the new one3. After soldering NOR chip, short points A20 and 3,3V debug on the mobo
4. Plug in display to mobo (only display) , than plug in power supply, only to be sure that "magus boot" appears on display
5 . Solder: modchip, cables to points A20, A19 and reset-switch
6. Now you can switch on device with flashdrive with e2 software in USB port while pressing POWER button (on front panel). Software will be transfered in ca 10minutes.
7. Finaly reboot device, everything should works properly
