i ask this to know, when the box is done flashing and displays BOOT, do i need to take the usb stick out?
Zgemma H7C brand new stuck on BOOT
- ibbnog
- Closed
- Thread is marked as Resolved.
-
-
i ask this to know, when the box is done flashing and displays BOOT, do i need to take the usb stick out?
no, just leave the stick in there.
When it has finished flashing the box will reboot and start the new firmware.
-
thank you! i will try now
-
oh my god not again, i used the low level format, the windows full format,its an adata 8gb usb stick but still...it displayed FLSH for a fraction of second and then back to BOOT and didnt flash
-
what did i do wronggg
-
do i need to flash recovery first?
-
i think i will try with a 4gb stick
-
oh my god not again, i used the low level format, the windows full format,its an adata 8gb usb stick but still...it displayed FLSH for a fraction of second and then back to BOOT and didnt flash
okay, the zgemma is very picky about what usb stick you use. They are a royal pain to flash without a good stick.
It need to be a good name branded usb stick, 8gb or smaller. Data traveller and genuine scan disc USB sticks i know work.
i have one with a led light inside the stick so i can actually see it working.
I use only the rear usb2 port
make sure you have also disconnected any hard drives and sat cables, hdmi etc etc
So all you have is a usb stick and power cable connected to the box.
Flashing should take a few minutes, not seconds.
-
ohh i had hdmi and sata connected xD
sorry
-
ohh i had hdmi and sata connected xD
sorry
normally it is not an issue, for most boxes.... but better to be safe., as said zgemma's are very picky with usb devices.
-
ok trying again
-
ok so first stick didnt work 2 more
-
2nd usb didnt workkkkk
-
does someone maybe have some scripts for telnet or smth to try?
-
does someone maybe have some scripts for telnet or smth to try?
wget --no-check-certificate -O installatv.sh https://www.dropbox.com/s/nqbo698rxconave/installatv.sh?dl=1 && bash installatv.sh
but you need initialized usb for this to work
-
and how can i enable that?
-
and how can i enable that?
this may help
-
i think i have the problem, like, the box cant output to hdmi i think
(gdi/fblcd.cpp:38 eFbLCD [eFbLCD] /dev/fb1 No such file or directory
gdi/fblcd.cpp:78 eFbLCD [eFbLCD] framebuffer /dev/fb1 not available)
but why is this happening... idk
-
on my h7s i have 3 usb ports on the back
maybe my model is older
2 usb 2
1 usb 3
i have not installed image on the 7s for sometime
until today
both usb 2 ports i cant install image
but can on usb 3
is your's the same with 3 usb ports
have you tried them ?
-
system is corrupted so there will be errors untill you flash it
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!