Connecting 2 OSCAM servers?

There is 1 reply in this Thread which was already clicked 1,407 times. The last Post () by s3n0.

    Hello. I have 2 OSCAM servers. Server A and Server B. Server B is made up of proxy readers. How can I add Server B as a proxy reader in server A?


    Server B oscam.conf

    Code
    [cccam]
port                          = 12000
nodeid                        = 65A5475F10621456
version                       = 2.3.2


    Server B user.conf

    Code
    user = chris
pwd = SuperSecretPassword
group = 1
keepalive = 1


    Server A oscam.server

    Code
    [reader]
label                         = EpicStuffHere
protocol                      = cccam
device                        = 10.0.1.200,12000
user                          = chris
password                      = SuperSecretPassword
group                         = 1
dropbadcws                    = 1
cccversion                    = 2.3.2
ccckeepalive                  = 1


    With this config it connects, but it says connected to 0 of x cards.

    What should I check to figure out why I don't connect to any cards?

    Is cccam even the best method of linking the servers?


    Thanks,

    Chris

    Hi.


    You are asking incorrectly. Oscam is also a client (you connect to an external or your own card reader) and also acts as a server (ECM sharing).


    "oscam.server" = here you set up a connection to your internal reader (dvbapi internal oscam-user) or to some external reader (Oscam as a client)


    "oscam.conf" = here you set running Oscam server services (for ECM sharing) on a various protocols (cccam, newcamd, cs357x, ...)


    "oscam.user" = in this file you will set the internal oscam-user dvbapi or here you will add user accounts that will apply to the created Oscam servers (for cccam, newcamd, etc. that you have set in "oscam.conf")


    Note:

    If you want to connect with your Oscam to yourself, that is, connection to itself, to the internal card reader, then it is also necessary to use the dvbapi module - so it is necessary to configure a local dvbapi user - in the files "oscam.user" and "oscam.conf".


    More info about Oscam configuration files can be found here:

    https://wiki.streamboard.tv/wiki/OSCam/en

Your resource for OSCam softcam

Find configs, downloads, tutorials, and support for setting up and optimizing this open-source card server with wide protocol compatibility. Master the versatile OSCam softcam. Access support, configs, tutorials, and downloads for open-source card sharing and multi-protocol server management.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login