zgemma h7s openpli 8.0 help please

Hi dont know if im in thr correct section but could someone please help.

I put openpli 8.0 on my reciever the other day. already had openvix on two other partitions and open atv on another.

after installing oopenpli I whent to multiboot to go back to openvix as all settings good for motor usals etc but multiboot says no images found. I downloaded another image from open pli to another partition but when installed and press ok to boot crash. go back to multiboot and open pli doesnt see that image iether is there a way i can get back to my openvix image thank for any help

Hi just seen your reply i got sorted in the end but had to use recovery file put openvix back on luckily i had save setting image found that on setup so got everything running again

gave up on oopenpli using openvix a lot better image in my opinion

dont think you understand recovery file deletes everything reformats al 4 partitions and put new image on then i had settings for openvix saved on hdd

so when i used recovery file it put openvix in slot 1 and i used saved settings to get evetything back as i had it before as i was using openvix before putting openpli on

i didnt use backup put emmc recovery file formats everything and then i had saved setting on hdd for previouse image wont use openpli again put me right of