Hi team,
[apologies if this was previously raised but could not find any similar scenario here]
I have a motorized 80cm dish (using disecq 1.2) with a VU Zero+ 4K receiver (kernel version 4.1.20 / 20210407) and i am experiencing "no signal" issue on some TPs (mostly on 23e when most of the signal strength on the majority of them is above 60%) and/or signal oscillation varying from 35% down to 10% on a couple of TPs (Hispasat) without reason (I'm on OpenPLi 8.2).
Previously i had a Formuler F4 turbo and never had any similar behaviour (and no setup was changed only the receiver).
I am tempting to test with other coax cables but would rather have your opinion/suggestions first because I read on several forums that it might be tuner/hardware related and, if the case, no solution is currently available .
thanks in advance for your replies.