vu+ solo se backup

There are 2 replies in this Thread which was already clicked 603 times. The last Post () by master G.

    greetings,qwestion about backup file.how to use backup files on open pli 8,2.i want to retrive settings and cams on new installed image.i was earlier created backup and that folder is named backup,

    • Official Post
    Quote from egog

    how to use backup files on open pli 8,2

    Its used the same way as any base image you would download.


    Article
    How To Flash A VU+ SOLO SE Linux Enigma2 Receiver
    Flashing the Receiver:

    – Fully power the receiver down by the toggle switch at the rear of the receiver.

    – Make sure no USB devices are plugged into the receiver at this point.

    – Insert the USB stick containing the image files into the USB port on the receiver.

    – Power the receiver on.

    – The Blue L.E.D will quickly flash two or three times then start to fade in and out slowly.

    – Once completed the Blue L.E.D will flash rapidly.

    – If in doubt leave the receiver for a full 10 minutes…
    world-of-satellite.co.uk

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login