hello all
I have a question hope someone can answer it.
I want to change the N: LINE with someone, but do not know how I create it, in newcamd I have port 17000, and in CCcam, I have port 12 007 of which ports should I use when I give N: line to anyone? then how do I do with F: LINE?
N:line help
- toni
- Thread is marked as Resolved.
-
-
Eh Toni,
Intro please i did ask you on your last post!
In the interest of fairness whack an into here please my friend Forum Gateway - Powered by DnP Firewall
Then the Genie will answer you wish!
-
Toni,
Have a look here to start it explains the basics
http://linuxsat-support.com/ca…nes-clines-beginners.html
In answer to your direct question,
It would depend on what protocol your sharing with and/or what protocol the user is using to connect to you!
If your sharing with Newcamd it would be 17000 if Cccam 12007in general lines are written like so and placed in Cccam.cfg file
C: YOURIPADDRESS PORTNO USERNAME PASSWORD - You can add sharing restrictions e.t.c after the PASSWORD which is explained in the link above
However,
If your sharing with Newcamd the line would be similar to
CWS = YOURIPADDRESS PORTNO USERNAME PASSWORD 01 02 03 04 05 06 07 08 09 10 11 12 13 14
If you have setup a No-IP or Dydns account this would be/replace YOURIPADDRESS in the examples given.
Someone will add/comment on this but the basics are in the link
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!