Memorize position?

There is 1 reply in this Thread which was already clicked 999 times. The last Post () by digi247.

    On my Dm800hd, when I go to any ***uk channel,the signal strength is around 90% and the reception is perfect. Now I go to BBCHD and there is nothing. So I open menu.go to setup,service searching,positioner setup and fine tune to around 90% signal and save using the geen button. When I open a channel ,the dish goes back to the original position so I then lose the strong BBC signal.any advice please...Ricky

    It all depends on what motor you are using if its a USALS diseqc motor then if your system is set for USALS you cannot fine tune any other satellite and save it as USALS is software based and works for your longitude and latitude details, Your only option would be to switch to advanced mode and use Diseqc 1.2 so far all the other satellites that are ok just set the option for 'Use usals for this Sat' to yeas and the ones that are slightly out select no and fine tune each one individually.


    You would of course have to do this if you where using a 36v motor anyway.

Master your satellite setup with expert installation support.

Get dish alignment help, LNB guidance, and configuration tips for single, multi, and motorized systems. Your technical forum for satellite installation. Get support for LNBs, DiSEqC switches, motorized systems, actuators, and dish alignment for any setup.