Thanks for the image to rescue my spark. I uploaded it successfully however the remote didn't work nor the buttons on the stb panel could help but to navigate up, down and left, right.
Any further help would be much appreciated
GM 990 CR HD PVR (SpARK rELOADED): Remote didn't work with the rescue image
- foxicon
- Thread is marked as Resolved.
There are 8 replies in this Thread which was already clicked 3,485 times. The last Post () by rami.
-
-
Thanks for the image to rescue my spark. I uploaded it successfully however the remote didn't work nor the buttons on the stb panel could help but to navigate up, down and left, right.
Any further help would be much appreciatedjust press prog+ a few times....then remote will work when u press Menu....then sat install....had same problem myself....ta..
-
just press prog+ a few times....then remote will work when u press Menu....then sat install....had same problem myself....ta..
I have just reflashed my box using the rescue image but the remote or the buttons on the front wont work the start up config. the only buttons that work are theP+, P-, V+, V- to move language
Im stuck now with this in this mode and cant get a spark image on it now because ive flashed it with the rescue one.any help would be gratefully appreciated
-
Hey Guys help please. My GM spark reloaded remote does not work after installing this rescue image voor gm reloaded.
??? -
Same problem.
-
sam e probl and still no answers?
-
same problem and no introduction will get you nowhere either..
-
Remote works fine on this rescue image for Reloaded receivers
Remember not p+ move menu with page+
-
hi,normaly afther you flash image rescue ,youshud reflash with last image spark and all good , then you can flash image eenigma 2
-
master G
Moved the thread from forum Golden Media 990 CR HD Support to forum Amiko Alien Mini SHD 8900 Spark STI 7111 Support.
Spark STI 7111 Support
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!